Hongxin steel pill, trustworthy! Welcome to the Hongxin official website

　　Shot blasting production process needs the effective ratio of steel shot and steel sand to produce qualified products, so how to match steel shot and steel sand? The steel shot manufacturer introduces this detail to everyone, so that everyone does not know how to match when shot blasting.

　　The steel sand manufacturer found that with the increase of the production time of the shot blasting machine, a large number of steel sand flew out along the gap of the chamber of the hook shot blasting machine when the shot blasting machine was used. It causes more waste than necessary, and it also causes the phenomenon of steel shot and sand flying out and hurting people. The shot manufacturer recommends that you pay attention to the following three points to avoid this phenomenon:

　　1. Match the proportion of steel shot and steel sand reasonably, increase the fluidity of steel shot and steel sand, reduce the residence time of steel sand in the shot blasting machine room, and form a good circulation process.

　　2. Reasonably arrange the tooling of the shot blasting machine to eject the workpiece, so that the steel sand feed of the shot blasting machine can be ejected on the workpiece surface, so as to reduce the damage caused by the steel sand hitting the chamber guard plate of the hook type shot blasting machine.

　　3. The maintenance workers of hook type shot blasting machine shall check the use of the machine frequently. If there is any damage to the body of the shot blasting machine room, the rubber strip with very sealed protective plate of the body of the shot blasting machine room shall be replaced in time to avoid more waste.