Hongxin steel pill, trustworthy! Welcome to the Hongxin official website

　　In the production process of casting shot blasting, effective ratio of steel sand and steel shot is needed to produce qualified products. How about the ratio of steel shot and steel sand? The steel shot manufacturer introduces this detail to you, so that you don't know how to match when you are shot blasting.

　　It is found that with the increase of casting time, a large amount of steel sand flies out of the gap of the chamber of the hook type shot blasting machine. Cause more waste than necessary, but also shot steel sand flying out of the phenomenon of injury. The steel shot manufacturer suggests you pay attention to the following three points to avoid this phenomenon:

　　1. In order to increase the fluidity of shot steel sand and reduce the residence time of shot blasting machine steel sand in the chamber, a good circulation process can be formed.

　　2. The reasonable layout of the tooling of the shot blasting machine, so that the shot blasting machine steel sand into the surface of the workpiece, in order to reduce the damage caused by the steel sand impact on the hook type shot blasting machine chamber guard board.

　　3. The maintenance workers of hook type shot blasting machine should often check the use of the shot blasting machine. If the shot blasting machine chamber is damaged, the protective plate of the shot blasting machine chamber should be replaced in time, so as to avoid greater waste.